![]() To ensure safe operation, the opener should be checked regularly.After installation, keep the instruction manual near the garage door.For modern garages, it is important to read and follow all safety and operating instructions before using the product for the first time.Learn More: How To Make Wooden Garage Doors A Smart Guide to Programming Garage Door Remotes It is always important to check the status of the garage door motor. If you have more than one handheld remote to use for garage door opener control, repeat the same steps to reprogram the other old motor unit.This is a signal that the old Craftsman garage remote has been programmed with the new remote.When the lights start flashing, release the button you pressed.This may take a few seconds to half a minute.Press and hold both buttons for a few seconds, and the light on the garage door opener will flash.This is done by holding the open/close button on the remote control with the fingers of one hand.Return to the installed garage door opener and locate the SRT button on the back of the garage door opener.Step 4: Press the SRT button to open the garage door. If there is more than one button on the remote, you can press any of them.Remove the new garage door remote and press and hold the “up” button.Step 3: Tap the “Up” radio button on the remote control. ![]() When you do so, the button will light up for half a minute. Find the “Learn to Open” button on the back of the garage door.I have located the “Learn” switch on that garage door opener. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |